Waiting (max 60 seconds) for system process `vnlru_mem' to stop.done Waiting (max 60 seconds) for system process `vnlru' to stop.done *** FINAL System shutdown message from *** *** System shutdown message from lab1 *** If planning to halt only one member use the member option Warning: This command will halt all the members. LAB Output: CLI command: request system halt request system halt > Please check the following output from EX4200 switch. EX4200 and EX4500 switches, the CLI command request system power-off behaves the same as request system halt. To exit the menu without rebooting the switch, press the Menu button again.Select the SYSTEM REBOOT option and press the Enter button.When the MAIN MENU (Maintenance menu) appears, press the Enter button.From the LCD front panel menu push the Menu button.To restart the switch from the front panel: This command will also notify other users connected to the switch about the operation and will restart the device in one minute. Disconnect power from the switch by pulling out the plug end of the power cord connected the power source outlet.For information about the request system halt command, see the Junos OS command documentation. Wait until a message appears on the console confirming that the operating system has halted. On the console or other management device connected to the switch (to the primary switch in a virtual chassis), enter the CLI operational mode and issue the following command to shut down the switch software: request system halt This command will also notify other users connected to the switch about the operation. Use the CLI command request system power-off from operational mode, which displays a message to the CLI, then disconnect the switch from electrical power. The information below describes the recommended method to safely turn off, halt, or restart the EX-series switch.
0 kommentar(er)
